Mod-U-Rail Kits Ordered

Since I will need to get a layout together in a relatively short period of time, I sent out the order for the Woodland Scenics Mod-U-Rail system today. I ordered two of the corner modules (ST4802) and a single straight module (ST4801) from Internet Hobbies, Inc. I am trusting that they will deliver since I haven't ordered from them before. They had what I was looking for and most importantly, they accepted PayPal. The modules should be here by December 21, 2005.

Comments

Post a Comment

Popular posts from this blog

Track Laying

Image
Laid the first track in the area that will eventually be a tunnel and hidden staging yard. Glued down the roadbed material and then glued the track to the roadbed. Installed a tortoise for the main yard turnout using hot glue gun. Had to mount the tortoise off to the side since I didnt want the switch machines hanging from the bottom of the module. See the photo below for details. Tunnel Trackage West Staging Throat Tortoise Install
Read more

Digitrax Equipment Arrives

Image
The Digitrax equipment has arrived! Unfortunately, there was a problem with the order and I got four Hare decoders (the ones that plug onto the Tortoise switch machines) instead of the four Tortoise switch machines. Looks like I will need to arrange for a Tortoise and Hare exchange ... :-) Digitrax Equipment - (clockwise from the upper left) PS12 Power Supplies, Zephyr Starter Set, USB LocoBuffer II, BDL168 Block Occupancy Detector, DS64 Stationary Decoder, DN163A1 Mobile Decoders Zephyr Starter Set - (clockwise from the upper left) LT1 LocoNet Test Kit, PS315 Power Supply, DCS50 Command Station/Booster/Throttle, Manuals USB LocoBuffer II - (clockwise from the upper left) Power Supply, Installation Disk, LocoNet Cable, Manual, LocoBuffer II, USB to Serial Adapter
Read more

Initial Decoder Testing

Image
In a rush to try things out, I jury rigged a piece of test track and fired up the Digitrax Zephyr DCS50. After screwing around with the buttons for a while, I finally gave up and dug out the manual. I followed the startup tutorial in the manual and was quickly up and running. It took another trip to the manual to get the lights working. I had forgotten that the lights were under function control. The speed was uncomfortably fast so I will probably need to change some settings to limit the speed. I only shot it off the end of the test track once ... :-) I also need to figure out the address settings. I would like to have them respond to their road numbers, 8301 and 8302. Maiden Voyage Under DCC
Read more